OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0990

Transmission Fluid Pressure Sensor/Switch E Circuit High

Pressure switch E reads high, meaning pressure, when it should be vented. GM's 6T70/6T75 family uses E for switch 5 on the R1/4-5-6 clutch regulator valve; applying the low/reverse or 4-5-6 clutch moves that valve and should exhaust the switch. If the signal stays high after such an apply, with commanded clutch pressure at 700 kPa or more, the module counts it: 15 counts on the Saab 9-4X, 30 in GM's 2016 table. It is a Type C or Special No Trip code, so no MIL, and the adaptations of both clutches are frozen. According to Saab, normal debris in the fluid can set it intermittently without noticeable symptoms. A short to voltage on the signal wire has the same effect. P0989 is the stuck-low case.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 90

Possible causes

  • Switch 5 stuck open by a damaged film or debris high
  • R1/4-5-6 regulator valve not moving, switch stays pressurised medium
  • Signal circuit shorted to voltage or open inside the module low

Symptoms

  • No warning light, code stored only
  • Intermittent occurrence without noticeable symptoms
  • Shift quality declines over time

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0990

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication