OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0989

Transmission Fluid Pressure Sensor/Switch E Circuit Low

Pressure switch E reads low, meaning no pressure, when it should show pressure. GM's 6T70/6T75 family uses E for switch 5 on the R1/4-5-6 clutch regulator valve; the normally closed switch sees pressure while both the low/reverse and the 4-5-6 clutch are released. The module counts clutch releases after which the signal stays low, checked with commanded clutch pressure at 50 kPa or less: 18 counts in GM's 2011 tables and on the Saab 9-4X, 17 in the 2016 table. It is a Type C or Special No Trip code without MIL, and the adaptations of both clutches are frozen. Sonnax lists P0989 among typical switch failures in this valve body module. P0990 is the stuck-high counterpart; switches A to D use P0840 to P0878.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 89

Possible causes

  • Damaged or delaminated film in switch 5 of the valve body module high
  • Debris keeping pressure away from the switch medium
  • R1/4-5-6 clutch regulator valve sticking medium
  • Low fluid level low

Symptoms

  • No warning light, code stored only
  • Shifts into 4th to 6th or reverse gradually less smooth
  • Occasional limp mode if the fault persists

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0989

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication