OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0988

Transmission Fluid Pressure Sensor/Switch E Circuit Range/Performance

Range/performance fault of transmission fluid pressure sensor or switch E: the signal is electrically valid but does not fit the commanded clutch state or the pressure expected from other inputs. No manufacturer documents this code publicly. GM's 6T70/6T75 family, the one public user of switch E (switch 5 on the low/reverse and 4-5-6 regulator valve), folds such plausibility checks into P0989 and P0990; its switch logic table shows which gears should pressurise the switch. Sonnax describes how these normally closed film switches in the valve body module fail through debris or delaminated films. CARB requires rationality checks of transmission inputs. Siblings: P0987 circuit, P0989 low, P0990 high.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 88

Possible causes

  • Damaged or delaminated switch film, switch reacts late or not at all high
  • Debris in the fluid holding the switch or its regulator valve medium
  • Low fluid level or real pressure deviation in the clutch circuit medium

Symptoms

  • Often no noticeable symptom at first
  • Shift quality worsens because adaptation stops
  • Warning light depending on manufacturer

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0988

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication