P0987
Transmission Fluid Pressure Sensor/Switch E Circuit
General circuit fault of transmission fluid pressure sensor or switch E. No manufacturer documents this code publicly. The only public user of switch E found, GM's 6T70/6T75 family (Saab 9-4X: switch 5 on the low/reverse and 4-5-6 clutch regulator valve), reports only P0989 and P0990 for it, both as plausibility counts. P0987 is the slot for a module that sees a generic circuit fault on a fifth pressure sensor or switch, for example an open or out-of-range signal, without separating low from high. CARB requires circuit checks on transmission inputs. Range/performance is P0988, low and high are P0989/P0990; switches A to D use P0840 to P0878. Typical effects are frozen shift adaptations and harsher shifts.
Possible causes
- Failed pressure sensor or switch E high
- Open or shorted signal wire or poor connector contact medium
- Faulty input stage in the transmission control module low
Symptoms
- Warning light depending on manufacturer
- Harsher or less consistent shifts
- Possible limp mode
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0987
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.