P0984
Shift Solenoid E Control Circuit Range/Performance
Range/performance fault in the drive circuit of shift solenoid E. Ford checks SSE with P0770, P0985 and P0986 only, GM's documented tables never reach letter E, and even Ferrari's DCT list, which reuses most of its neighbours, skips P0984. The one codegenau source is FCA: in recall S55 for the 9-speed front-drive transaxle it names P0984 together with P0975, P0978 and P0981. Under old TCM software, a range sensor harness with poor crimps and intermittent high resistance could set them; with new software the same fault shows as P0901, and these four codes then point to a separate transmission problem. Otherwise the code rests only on the CARB rule for transmission output checks. Low/high are P0985/P0986.
Possible causes
- Range sensor harness with weak crimps (FCA 9-speed recall) high
- TCM software below the recall level medium
- Internal transmission fault when the code returns after the update medium
- Faulty driver stage in the control module low
Symptoms
- Sudden neutral or loss of drive (FCA 9-speed)
- MIL or transmission warning on
- Limp mode
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0984
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.