OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0983

Shift Solenoid D Control Circuit High

High-voltage fault in the control circuit of shift solenoid D. Ford defines it narrowly as SSD short to power; the open circuit stays with P0765. On the 6R140 the solenoid outputs are run by a smart driver chip (ADLER) that does the open and short checks itself, while older units use a feedback line from the output stage; both need 0.5 to 5 s. Since SSD on Ford six-speeds controls the low/reverse clutch, either alone or through the multiplex valve, a constant power short can apply that clutch at the wrong time. The 2020–2023 gasoline summary keeps the same assignment. GM documents no P0983 for its geared automatics, and Ferrari uses it for an actuator 3 sensor reading too high. Ground faults are P0982.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 83

Possible causes

  • Solenoid D control wire shorted to a supply high
  • Solenoid D with shorted windings medium
  • Conductive contamination between neighbouring pins medium
  • Faulty smart driver or output stage in the module low

Symptoms

  • MIL on, default gear
  • Clunk or tie-up feel if the low/reverse clutch applies unintentionally
  • Upper gears blocked

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0983

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication