P097C
Shift Solenoid C Control Circuit/Open
Open-circuit fault in the drive circuit of shift solenoid C. GM documents it for the Allison 1000 six-speed in its 2022 to 2025 heavy-duty tables as Shift Solenoid 3 Control Circuit Open, with the same intrusive low-side test as SS1 and SS2: three samples, 120 ms, battery 9 to 18 V, MIL after one trip. It is the youngest of three codes for this one fault on that gearbox: 2007 used P0978, only outside reverse trim, 5th and 6th gear, 2016 merged it into P0979 with a 200 kOhm limit. Ford reports an open SSC under P0760, and no other maker was found using P097C. A related pressure switch code may set too, because SS3 strokes the S3 valve that switch PS3 watches.
Possible causes
- Open coil of shift solenoid 3/C high
- Loose, wet or corroded pin in the transmission connector high
- Broken wire between module and solenoid C medium
- Faulty low-side driver in the control module low
Symptoms
- MIL on after one faulty trip
- Upper gears unavailable or fixed default gear
- Possible additional pressure switch code
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P097C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.