P0978
Shift Solenoid C Control Circuit Range/Performance
Range/performance fault in the drive circuit of shift solenoid C. GM's 2007 Allison 1000 table used it for an open SS3 circuit, but only while the commanded gear is not reverse trim, 5th or 6th; the table even prints the label Circuit Low beside an open-circuit test, an apparent typo. FCA lists P0978 among the four codes that the 2014–2016 9-speed transaxle set under old software when the range sensor harness had poor crimps. Ferrari's DCT bulletin uses it for a missing signal from the actuator 4 engage position sensor. Ford and GM six-speeds do not use it. Low/high are P0979/P0980, the current open code P097C.
Possible causes
- Intermittent high resistance at crimped harness terminals (FCA 9-speed) high
- Open coil of shift solenoid C (Allison-type usage) medium
- Transmission software that predates the manufacturer's fix medium
- Faulty driver stage in the transmission control module low
Symptoms
- MIL or transmission warning on
- Sudden neutral or default gear while driving
- Erratic or missing shifts
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0978
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.