OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0977

Shift Solenoid B Control Circuit High

High-voltage fault in the control circuit of shift solenoid B. GM six-speeds put an open or a power short of the mode 3 multiplex valve here, 1.2 of 1.5 s; the 2016 table sets it without MIL, the 2019 table with MIL after one trip. The Saab 9-4X 6T70 treats it more severely than P0976: 2 s, Type A, high-side driver off, only reverse and 5th gear left, no converter lockup. Ford uses it strictly for SSB short to power, as in its 2012 and later summaries. GM's Allison 1000 checks for 0.39 ohm or less to a supply over three samples (75 ms in 2016, 60 ms in 2023). FCA 9-speed and Aisin uses are not documented for this code. Ground-side faults are P0976.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 77

Possible causes

  • Open solenoid B coil or wire on GM six-speeds, where opens report as high high
  • Control wire shorted to battery or a switched supply medium
  • Damaged pins or seals at the transmission pass-through connector medium
  • Faulty driver stage in the control module low

Symptoms

  • Limp mode with only reverse and one high forward gear
  • Weak acceleration from rest
  • MIL or transmission warning, depending on calibration

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0977

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication