P0975
Shift Solenoid B Control Circuit Range/Performance
Range/performance fault in the drive circuit of shift solenoid B. Three documented uses differ widely. GM's 2007 Allison 1000 table used it for an open SS2 circuit, confirmed by an intrusive low-side test (400 ms, Type A). FCA's 2016 recall for the 9-speed front-drive transaxle (Cherokee, 200, Renegade, 500X, ProMaster City) names P0975 with P0978, P0981 and P0984 as the codes set by intermittent high resistance from poorly crimped terminals in the range sensor harness under old TCM software; updated software reports that case as P0901 instead. Ferrari's DCT uses P0975 for a missing actuator 2 position signal. Low/high are P0976/P0977.
Possible causes
- Poorly crimped terminals causing intermittent high resistance (FCA 9-speed recall) high
- Open or high-resistance coil of shift solenoid B medium
- Outdated transmission software that misreads harness resistance medium
- Faulty driver stage in the transmission control module low
Symptoms
- MIL or transmission warning on
- Unexpected shift to neutral or loss of drive (FCA 9-speed)
- Fixed default gear or harsh shifts
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0975
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.