OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0974

Shift Solenoid A Control Circuit High

High-voltage fault in the control circuit of shift solenoid A. What it covers depends on the maker. Ford reserves it for a short to power on SSA, because an open SSA circuit sets P0750. GM six-speeds put both an open and a power short of the mode 2 solenoid here: 1.2 of 1.5 s, MIL only after two trips. The Saab 9-4X 6T70 waits 2 s, Type B, and then blocks 1st gear. GM's Allison 1000 tables of 2016 and 2023 treat it as a pure power short (0.39 ohm or less, 3 samples, 75 or 60 ms) and report opens separately. Saab's Aisin gearbox in the 9-5 (2010) sets it when solenoid valve 2 reads off while commanded on, 100 ms five times, Type A. Ground-side faults are P0973.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 74

Possible causes

  • Open coil or broken wire where the maker reports opens under the high code (GM six-speed) high
  • Control wire shorted to a supply voltage medium
  • Spread or corroded pins at the transmission connector medium
  • Faulty driver stage in the control module low

Symptoms

  • MIL on, on GM six-speeds only after a second faulty trip
  • First gear locked out, start-off in a higher gear
  • Missing or wrong shifts, possibly limp mode

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0974

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication