OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0972

Shift Solenoid A Control Circuit Range/Performance

Range/performance fault in the drive circuit of shift solenoid A: the circuit is not plainly shorted, yet its electrical behaviour does not fit what the module commands. Today's large makers rarely use the code. GM's 2007 table for the Allison 1000 six-speed used it for an open SS1 circuit: after three hardware fault samples the module opens the low-side driver as an intrusive test and reports P0972 if four more samples show no short to ground (400 ms, Type A, MIL at once). Newer GM Allison tables move that open to P097A. Ferrari's DCT bulletin reuses P0972 for a missing signal from the actuator 1 engage position sensor, not a solenoid. Ford and GM six-speeds report opens elsewhere. Shorts are P0973/P0974.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 72

Possible causes

  • Open or high-resistance coil of shift solenoid A (Allison-type usage) high
  • Loose or corroded terminal at the transmission connector or internal harness medium
  • Chafed or broken wire between module and solenoid medium
  • Faulty driver stage in the transmission control module low

Symptoms

  • MIL or transmission warning on
  • Transmission falls back to a fixed default gear
  • Missing or abrupt shifts

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0972

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication