OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0971

Pressure Control Solenoid C Control Circuit High

Pressure control solenoid C circuit high: a short to voltage, and on GM six-speeds also an open, as there is no separate open code there. The Saab 9-4X 6T70 (clutch pressure solenoid 3, low/reverse and 4-5-6 clutches) and GM's 2018 six-speed table set it after 1 s or 0.3 s as Type A, with limp mode in reverse and 5th gear at maximum line pressure. GM's 8-, 9- and 10-speeds use the code for their clutch solenoid C; GM's dual-clutch gearbox for the redundant odd-clutch shutdown valve, where too high a voltage at the sense pin with the output switched on counts as a short. Ford does not use C codes. Siblings: P0968 open, P0970 low, P0969 performance. A loose connector can make the fault come and go.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 71

Possible causes

  • Open coil or poor connection (reported as high on GM six-speeds) high
  • Control wire shorted to a supply voltage medium
  • Damaged or loose transmission connector medium
  • Faulty output stage in the control module low

Symptoms

  • MIL on, limp mode in a fixed gear
  • Harsh engagements at maximum line pressure
  • Fault comes and goes with temperature or vibration

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0971

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication