P0970
Pressure Control Solenoid C Control Circuit Low
Pressure control solenoid C circuit low, a short to ground in the driver. On GM's six-speeds C is the C456/CBR1 solenoid; on the Saab 9-4X 6T70 it is clutch pressure solenoid 3 for the low/reverse and 4-5-6 clutches. A short for 1 s (Saab) or 0.3 s (GM 2018 table) sets a Type A code: only reverse and 5th gear, no converter lock-up, maximum line pressure. GM's 8-speed uses C for clutch 3 (C13567), the 9- and 10-speeds for CB38 or C23457910 with less than 0.5 ohm counting as a short; GM's dual-clutch gearbox uses it for the odd-clutch shutdown valve. Siblings: P0968 open, P0971 high, P0969 performance. Since the solenoid sits in the valve body, repairs often mean the control solenoid valve assembly.
Possible causes
- Internally shorted solenoid in the control solenoid valve assembly high
- Chafed control wire touching ground medium
- Fluid or moisture in the connector medium
- Faulty output stage in the control module low
Symptoms
- MIL on immediately
- Limp mode in reverse and one forward gear
- Weak acceleration from standstill
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0970
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.