P0969
Pressure Control Solenoid C Control Circuit Range/Performance
Performance fault of pressure control solenoid C. Publicly documented only for GM's front-drive six-speeds: on the Saab 9-4X 6T70, clutch pressure solenoid 3 feeds the low/reverse and 4-5-6 clutches through the R1/4-5-6 regulator valve. If measured current differs from the commanded current for 5 s, the module stores a Type C code and freezes the adaptations of both clutches. GM's 2016 table (C456/CBR1 solenoid) sets it after an invalid feedback for 4.4 of 5 s, also without MIL. Other GM users such as the 8- to 10-speeds list only open, low and high for C, and Ford does not use C. Drivers rarely notice more than gradually rougher 4-5-6 or reverse engagements. Electrical faults: P0968, P0970, P0971.
Possible causes
- Solenoid 3 with internal fault, current no longer matches the command high
- Debris sticking the solenoid or the R1/4-5-6 regulator valve medium
- High resistance in the internal connection to the module low
Symptoms
- Usually no warning light
- Rougher shifts into 4th, 5th, 6th or reverse over time
- Shift adaptation stops learning
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0969
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.