OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0966

Pressure Control Solenoid B Control Circuit Low

Pressure control solenoid B circuit low, meaning a short to ground in the driver circuit. On GM's six-speeds and the Saab 9-4X 6T70, B is clutch pressure solenoid 2 for the 3-5-reverse clutch; a short lasting 0.3 s (GM 2018 table) or 1 s (Saab) sets a Type A code with a fixed limp mode: reverse and 5th gear, maximum line pressure, converter clutch off. GM's 8-, 9- and 10-speeds use B for a clutch solenoid and treat less than 0.5 ohm as a short; Allison 1000 uses it for pressure control solenoid 2 with ground-short detection in 125 ms. Ford does not use the B codes. Siblings are P0964 open, P0967 high and P0965 performance; solenoids A and C follow the same scheme.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 66

Possible causes

  • Chafed control wire touching ground high
  • Internally shorted solenoid in the valve body assembly medium
  • Fluid or moisture in the connector medium
  • Faulty output stage in the control module low

Symptoms

  • MIL on immediately
  • Limp mode with reverse and one forward gear
  • No torque converter lock-up, higher fuel consumption

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0966

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication