OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0964

Pressure Control Solenoid B Control Circuit/Open

Open circuit in the driver of pressure control solenoid B. What B controls differs by gearbox: GM's 8-speed uses it for clutch 2 (CB12345R), the 9-speed for CB29 and the 10-speed for CB128910R, Allison 1000 for pressure control solenoid 2, and GM's dual-clutch gearbox for the even-clutch pressure valve. GM sets it at more than 200 kOhm for 0.3 s (Type A, one trip), Allison at 173 kOhm or more after an intrusive test, the dual-clutch unit after 150 ms. GM six-speeds do not use P0964; an open in their 3-5-reverse solenoid shows up as P0967. Ford's OBD summaries list no B or C codes. Depending on the clutch involved, gears are lost or the unit drops into a fixed limp gear. Siblings: P0965, P0966, P0967.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 64

Possible causes

  • Open solenoid coil high
  • Poor contact at the transmission connector or internal harness medium
  • Broken control wire medium
  • Faulty output stage in the control module low

Symptoms

  • MIL and transmission warning on
  • Certain gears missing or limp mode
  • Dual-clutch gearbox drives on one sub-gearbox only

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0964

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication