OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0962

Pressure Control Solenoid A Control Circuit Low

Pressure control solenoid A circuit low: the driver sees a short to ground. Ford tests its line pressure (EPC) solenoid this way; a short there opens a high-side switch that cuts power to the shift solenoids and leaves park, reverse, neutral and one fixed forward gear at maximum line pressure. On GM's six-speeds and the Saab 9-4X 6T70, A is the line pressure solenoid; the fault matures in 1.5 to 2 s and is Type A, with reverse and 5th gear only, no converter lock-up and maximum line pressure. GM's 8-, 9- and 10-speeds use A for a clutch solenoid and treat less than 0.5 ohm as a short, Allison 1000 for main modulation pressure (125 ms). Siblings: P0960 open, P0963 high, P0961 performance.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 62

Possible causes

  • Control wire chafed through and touching ground high
  • Internally shorted solenoid coil medium
  • Transmission fluid or water in the connector bridging pins medium
  • Faulty output stage in the control module low

Symptoms

  • MIL and transmission warning on immediately
  • Limp mode with only one forward gear and reverse
  • Harsh engagements, poor acceleration from standstill

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0962

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication