OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0960

Pressure Control Solenoid A Control Circuit/Open

Open-circuit fault in the driver circuit of pressure control solenoid A: the module measures an impedance far above the coil value, as if a wire, pin or winding were broken. Which solenoid carries the letter A depends on the gearbox. Ford uses it for the line pressure (EPC) solenoid; GM's 8-speed for clutch 1 (CB1278R), the 9- and 10-speeds for clutch CB123456(R), Allison 1000 for main modulation (line) pressure and GM's dual-clutch gearbox for the odd-clutch valve. GM flags more than 200 kOhm for 0.3 s (Type A), Allison 173 kOhm or more after an intrusive test. GM six-speeds report an open under P0963 instead. Low and high are P0962/P0963, performance P0961. Expect maximum line pressure, harsh shifts or a fixed limp gear.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 60

Possible causes

  • Open solenoid coil inside the valve body or solenoid assembly high
  • Loose, corroded or pushed-back pin at the transmission connector or pass-through medium
  • Broken wire between module and solenoid medium
  • Faulty output stage in the transmission control module low

Symptoms

  • Transmission warning or MIL on, fault message in the cluster
  • Very firm or harsh shifts due to maximum line pressure
  • Transmission stays in a fixed limp gear

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0960

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication