P095C
Gear Shift Position Circuit C Low
The signal of shift position sensor C in an automated manual gearbox lies below its permitted voltage window. Typical reasons are a signal wire shorted to ground, a lost sensor supply or a sensor with an internal fault pulling its output down. Because the value is physically impossible, the control unit can flag it quickly without comparing it to other channels. No manufacturer documents this code publicly. A Nissan/Aichi patent shows shift stroke sensors as the position feedback for gear engagement, an Aisin AI patent the fallback strategy when such a sensor drops out. CARB requires circuit checks on such inputs. P095D is the high counterpart, P095A the general and P095B the plausibility fault; P0916 and P091C are the low faults of A and B.
Possible causes
- Signal wire of sensor C shorted to ground high
- Open or shorted 5 V supply of the sensor medium
- Internally failed shift position sensor C medium
Symptoms
- Transmission or engine warning light on
- Fallback mode with restricted gears
- Gearbox may refuse to leave neutral
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P095C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.