P095A
Gear Shift Position Circuit C
Circuit C is a third channel reporting the shift position inside an automated manual gearbox, for example a further sensor track or a sensor on another shift rail or selector shaft. This general circuit code sets on an electrical fault of that signal that fits none of the more specific C variants. No manufacturer documents the code publicly, and which sensor carries the letter C depends on the design. A Nissan/Aichi patent describes shift stroke sensors as the feedback for engaging gears, an Aisin AI patent the fallback when a stroke sensor fails. CARB requires circuit checks on such inputs. P095B to P095D are the C siblings, P0914 and P091A the same signal on circuits A and B. Shifting may be restricted.
Possible causes
- Loose or corroded connector at shift position sensor C high
- Damaged signal, supply or ground wire of sensor circuit C medium
- Faulty shift position sensor C medium
- Faulty sensor input in the transmission control module low
Symptoms
- Transmission or engine warning light on
- Slower or restricted gear changes in fallback mode
- Gearbox may hold a gear or stay in neutral
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P095A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.