P0954
Auto Shift Manual Control Circuit Intermittent
The manual up/down request signal drops out or flickers for short moments, so a single tap may arrive twice, late or not at all. Unlike P0952 and P0953 the voltage is not stuck outside its window; it jumps between states without a matching lever movement. Typical triggers are loose pins in the shifter connector, worn contacts or a harness that flexes with the lever. A Chrysler patent shows how simple contact switches in the gate signal each request, a Volkswagen patent how Hall tip sensors and their lines are checked. No manufacturer documents this exact code publicly; CARB requires circuit checks. P0950 is the general fault. The driver notices missed or doubled manual shifts.
Possible causes
- Loose or spread pins in the selector lever connector high
- Harness broken internally where it moves with the lever or steering column medium
- Worn or oxidised tip switch contacts medium
Symptoms
- Manual shifts occasionally ignored or executed twice
- Fault comes and goes, often over bumps
- Manual mode temporarily switched off
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0954
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.