P094E
Hydraulic Pump Supply Voltage Circuit/Open
Fault in the power feed of the hydraulic or electric oil pump: fuse, supply wire, connector or relay output. The module sees missing or implausible supply at the pump or its controller. No manufacturer documents this exact code publicly. Mercedes shows the checks that belong to it on the electric auxiliary oil pump of the 722.9 automatic, although it reports that pump under P0944: connector and fuse first, then supply voltage and CAN lines. Hyundai lists an open circuit of its DCT high-flow pump as P193D13. CARB requires circuit checks on outputs. P0945 to P0948 concern the control side, P094A the driver, P0562 general low system voltage. Without supply the pump stops and stop-start is usually blocked.
Possible causes
- Blown pump fuse high
- Open or corroded supply wire or connector medium
- Weak battery or poor main ground lowering pump supply voltage low
Symptoms
- Warning light on
- Pump does not run
- Stop-start disabled or gearbox in limp mode
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P094E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.