P094D
Hydraulic Pump Over Temperature
The hydraulic or electric oil pump, or its integrated controller, has become too hot. The temperature is usually measured on the controller board and the pump is derated or switched off to protect it. No manufacturer documents this exact code publicly. Hyundai lists the same condition for the high-flow pump of its wet 8-speed DCT as P193D4B, over temperature, and P1C2E92 for the high-pressure pump motor control. Kia recalled stop-start oil pump controllers in 2023 because a damaged capacitor could short and overheat the board, harness and connector. CARB requires functional checks on outputs. P094A is the driver fault, P094B a pump that never stops, a common reason for heat build-up.
Possible causes
- Pump running too long because of leakage or a stuck relay high
- Defective pump controller board medium
- Very hot transmission fluid or blocked cooling low
Symptoms
- Warning light on
- Stop-start temporarily disabled
- Burning smell near the pump in severe cases
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P094D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.