P094B
Hydraulic Pump Stuck On
The hydraulic pump keeps running although the module has switched it off, or it never reaches its cut-out point. Causes are a welded relay or shorted driver, or a pump that cannot reach cut-out pressure because of leakage. No manufacturer documents this exact code publicly. In the pump and accumulator unit of an automated gearbox, described in a ZF patent, the pump should rest once the accumulator is charged. Toyota links a constantly buzzing pump on the MR2 sequential gearbox to fluid loss at the hydraulic power unit, reported under P0942. CARB requires functional checks on outputs. P094C is the opposite fault, P0946 the relay plausibility fault, P0943 the too-short cycle. Battery drain and pump wear follow.
Possible causes
- Pump relay contacts welded closed high
- Leakage or lost accumulator charge keeps pressure below cut-out medium
- Shorted driver stage or supply wire shorted to battery voltage medium
Symptoms
- Pump audible after the vehicle is switched off
- Discharged battery
- Warning light on
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P094B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.