OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0949

Auto Shift Manual Adaptive Learning Not Complete

Status code for an automatically shifted manual gearbox: the control unit has not yet finished learning its adaptation values, above all the clutch touch point and the end positions of the shift actuators. Such learning runs after a new control unit, clutch or actuator, after a software update and sometimes after the battery was disconnected; Hyundai and Kia patents show how the touch point is found and corrected from shaft speed changes. No manufacturer documents this exact code publicly. The code is a reminder rather than a hardware fault; launch and shifts may be jerky until learning is done. P0950 to P0954 cover the manual control circuit, P0806 to P0808 the clutch position sensor. MIL use depends on the maker.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 49

Possible causes

  • Relearn not run after clutch, actuator or control unit replacement high
  • Adaptation values erased by software update or battery disconnection medium
  • Learning aborted by low voltage or worn clutch outside the learn window medium

Symptoms

  • Jerky launch or rough shifts
  • Gearbox warning or message to perform teach-in
  • Restricted gear selection until learning completes

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0949

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication