P0948
Hydraulic Pump Relay/Control Circuit High
The control line of the hydraulic pump relay or driver shows a higher voltage than expected, typically because it is shorted to battery voltage or the relay coil is open on a low-side driver. The pump then cannot be switched on, or the module sees it as active when it is not. J2012 places this code with the pump control circuit; Ferrari however reads P0948 on its DCT as no signal from the system pressure output, an unrelated use. The pump and accumulator unit of an automated gearbox is described in a ZF patent. CARB requires circuit checks on transmission outputs. P0947 is the low counterpart, P0945 the open fault and P0946 the plausibility fault. Expect a warning and possible loss of pump pressure.
Possible causes
- Relay control wire shorted to battery voltage high
- Open relay coil seen as high level by the driver medium
- Control module fault low
Symptoms
- Warning light on
- Pump does not start
- Gear changes not possible or stop-start disabled
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0948
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.