P0947
Hydraulic Pump Relay/Control Circuit Low
The voltage on the control line of the hydraulic pump relay or driver is lower than the module expects for the commanded state. Usually the line is shorted to ground or the relay coil is shorted, so the output may be overloaded and the pump runs when it should not, or the driver shuts down. No manufacturer documents this exact code publicly. The hydraulic unit it belongs to, a motor-driven pump that charges an accumulator for the shift and clutch cylinders of an automated gearbox, is described in a ZF patent. CARB requires circuit checks on transmission outputs. P0948 is the high counterpart, P0945 the open fault, P0946 plausibility. Pressure supply for shifting may fail.
Possible causes
- Relay control wire chafed and shorted to ground high
- Shorted relay coil medium
- Damaged output stage in the control module low
Symptoms
- Warning light on
- Pump runs continuously or not at all
- Gearbox in limp mode or stop-start disabled
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0947
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.