P0946
Hydraulic Pump Relay/Control Circuit Range/Performance
The pump control circuit is electrically intact, but its behaviour does not match the command, for example a pump that keeps running after being switched off, or one that switches but is not followed by the expected feedback. No manufacturer documents this exact code publicly. In the hydraulic unit of an automated gearbox, as shown in a ZF patent, the pump only has to run until the accumulator is charged; a relay that sticks or switches late upsets that cycle. CARB requires functional checks on transmission outputs. P0945 is the general circuit or open fault, P0947 and P0948 the low and high faults, P094B a pump stuck on regardless of the relay. A pump that never stops drains the battery and wears quickly.
Possible causes
- Relay contacts welded or sticking high
- Pump supply or control wire shorted to battery voltage medium
- Faulty pump state feedback or control module low
Symptoms
- Pump keeps running after switch-off
- Warning light on
- Auto stop-start not available
- Battery discharged after parking
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0946
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.