P0945
Hydraulic Pump Relay/Control Circuit/Open
The control module drives the motor of the hydraulic pump through a relay or a direct output. This code reports a general circuit fault or an open in that control path, so the pump cannot be switched reliably. No manufacturer documents this exact code publicly. The layout is shown by a ZF patent for an automated gearbox, in which a motor-driven pump draws oil from a reservoir and charges a pressure accumulator behind a one-way valve, with shut-off valves feeding the shift cylinders. CARB requires circuit checks on transmission outputs. P0946 is the plausibility fault, P0947 and P0948 low and high; P094E covers the pump supply instead of the control side. Without the pump the gearbox soon runs out of pressure.
Possible causes
- Pump relay coil open or relay not seated high
- Open control wire or loose terminal between module and relay medium
- Failed output stage in the control module low
Symptoms
- Warning light on
- Pump does not run, pressure is not built
- Gears cannot be changed or auto stop-start disabled
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0945
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.