OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0943

Hydraulic Pressure Unit Cycling Period Too Short

In a hydraulic pressure unit the pump charges an accumulator up to a cut-out pressure and switches off until pressure falls to the cut-in point. By J2012 wording this code means the pump switches on again too soon, so the interval between charging cycles is shorter than expected. Typical reasons are internal leakage across valves or seals, or an accumulator that has lost its gas precharge and stores too little oil. Audi patents describe such accumulator and leakage checks based on charging switch-over times and pressure decay. No manufacturer documents this exact meaning publicly; Ferrari uses P0943 on its DCT for a system pressure command signal that is too high. CARB requires functional checks of transmission outputs. P0942 is the general fault, P0944 the loss of pressure.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 43

Possible causes

  • Accumulator has lost its gas precharge high
  • Internal leakage at valves, seals or actuator cylinders high
  • Faulty pressure switch or pressure sensor giving wrong cut-in point medium
  • Low or aerated hydraulic fluid low

Symptoms

  • Pump can be heard switching on unusually often
  • Warning light on
  • Slower or harsher gear changes

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0943

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication