P0942
Hydraulic Pressure Unit
General fault of the unit that generates and stores hydraulic pressure for an automated gearbox or its auxiliary oil supply: motor-driven pump, accumulator and pressure control. Toyota sets P0942 on the 2001 to 2005 MR2 Spyder sequential gearbox together with the SMT warning light and a buzzing pump, or with gears that can no longer be changed; fluid seeping from the reservoir cap or the seal of the hydraulic power unit is a known cause, fixed with new seal rings. Ferrari reads P0942 on its DCT differently, as system pressure command signal too low. CARB requires functional checks of transmission outputs. P0943 and P0944 are the cycling and pressure-loss faults, P0945 to P0948 the pump control circuit.
Possible causes
- Fluid loss at the reservoir cap or hydraulic power unit seals high
- Worn pump motor or faulty pump relay medium
- Damaged wiring, connectors or power supply of the pump medium
- Transmission control module fault low
Symptoms
- Transmission or gearbox warning light on
- Pump buzzing or running for long periods
- Gears cannot be changed or shifts are delayed
- Auto stop-start disabled or engine restarts immediately
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0942
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.