P0940
Hydraulic Oil Temperature Sensor Circuit High
The hydraulic oil temperature sensor signal sits above its valid window. With an NTC thermistor this matches an extremely cold reading, typically from an open circuit, an unplugged connector, a broken ground or a short to a voltage source. Ferrari uses P0940 on its DCT for the radiator outlet and gearbox inlet oil temperature sensor, described as an electrical fault with signal too high, read in the NCR gearbox ECU. CARB requires out-of-range checks on transmission sensors. P0939 is the low counterpart, P0937 the general circuit fault, P0938 plausibility and P0941 intermittent. With a substitute value the gearbox works on, but clutch and shift pressures are no longer matched to the real oil temperature.
Possible causes
- Open signal or ground wire, or connector unplugged high
- Temperature sensor open internally medium
- Signal wire shorted to a voltage source low
Symptoms
- Gearbox warning light on
- Shifts or clutch engagements feel rough once warm
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0940
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.