P093C
Hydraulic Accumulator Solenoid Circuit High
The control circuit of the hydraulic accumulator solenoid reads high, typically a control wire shorted to battery voltage so the driver cannot switch the valve as commanded. No manufacturer documents P093C publicly. GM covers the same fault on its surge accumulator solenoid with P171C: failed short to voltage when the circuit impedance criterion of 0.5 Ohm is met in 6 of 8 samples, Type B with MIL after two trips. GM's patent on an accumulator with solenoid valve shows how the valve holds or releases the stored fluid. P093A is the open circuit, P093B the low fault and P093D the performance fault. Stop-start is usually disabled; a valve that never closes cannot keep the accumulator charged during an auto-stop.
Possible causes
- Solenoid control wire shorted to battery voltage high
- Damaged internal transmission harness or lead frame medium
- Output driver in the control module failed low
Symptoms
- Warning light on (after repeated detection)
- Engine stop-start no longer active
- Jolt when pulling away after a restart
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P093C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.