P093B
Hydraulic Accumulator Solenoid Circuit Low
The control circuit of the hydraulic accumulator solenoid reads low, usually a control wire shorted to ground or a coil with very low resistance. No manufacturer documents P093B publicly. GM covers the same fault on its surge accumulator solenoid with P171B: failed short to ground when circuit impedance drops below 0.5 Ohm in 32 of 40 samples, Type B with MIL after two trips. The accumulator holds pressurised fluid so clutches stay applied during an engine auto-stop, as GM's stop-start accumulator patent explains. P093A is the open-circuit fault, P093C the high fault and P093D the performance fault. A grounded control line can leave the valve permanently energised, and stop-start is typically switched off.
Possible causes
- Solenoid control wire shorted to ground high
- Solenoid coil shorted internally medium
- Output driver in the control module failed low
Symptoms
- Warning light on (after repeated detection)
- Engine stop-start no longer active
- Harsh engagement after restart
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P093B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.