P093A
Hydraulic Accumulator Solenoid Circuit/Open
The control circuit of the solenoid that opens or locks a hydraulic accumulator in the gearbox is open. Such accumulators store pressurised fluid, for example to keep clutches applied during engine stop-start, as GM's patents on a stop-start accumulator and an accumulator with solenoid valve describe. No manufacturer documents P093A publicly. GM uses its own P171A for the same fault on the surge accumulator solenoid: failed if circuit impedance exceeds 200 kOhm in 32 of 40 samples, Type B with MIL after two trips. P093B and P093C are the low and high faults, P093D the performance fault. Stop-start is usually disabled, and the first restart may engage with a jolt.
Possible causes
- Accumulator solenoid coil open high
- Connector unplugged or wire broken between module and solenoid medium
- Fault in the internal transmission harness or lead frame medium
- Output driver in the control module failed low
Symptoms
- Warning light on (after repeated detection)
- Engine stop-start no longer active
- Jolt or slip when driving off after an engine restart
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P093A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.