P0939
Hydraulic Oil Temperature Sensor Circuit Low
The hydraulic oil temperature sensor signal sits below its valid window. With the usual NTC thermistor, a low voltage corresponds to an implausibly hot reading and typically comes from a signal wire shorted to ground or a sensor shorted internally. Ferrari uses P0939 on its DCT for the radiator outlet and gearbox inlet oil temperature sensor, described as signal too low and read in the NCR gearbox ECU. CARB requires out-of-range checks on transmission sensors. P0940 is the high counterpart, P0937 the general circuit fault, P0938 plausibility and P0941 intermittent. Because the module believes the oil is very hot, it may reduce torque, change shift strategy or show an overheat warning.
Possible causes
- Sensor signal wire shorted to ground high
- Temperature sensor shorted internally medium
- Control module input fault low
Symptoms
- Gearbox warning or overheat message
- Reduced performance or altered shift behaviour
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0939
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.