P0936
Hydraulic Pressure Sensor Circuit Intermittent
The hydraulic pressure signal drops out or jumps for short periods, too briefly or irregularly for a lasting low or high fault. No manufacturer documents this code publicly. The underlying sensor is the same one Chrysler uses for line pressure on RFE units and Ferrari for system pressure on its DCT, where the steady faults appear as P0934 and P0935. Gears Magazine names poor solder joints and crimps at the sensor terminals as a frequent source of intermittent pressure sensor codes. CARB requires circuit checks on such transmission inputs. P0932 to P0935 cover the general, plausibility, low and high faults. The driver may see a warning that comes and goes and occasional harsh shifts.
Possible causes
- Poor crimp or solder joint at the sensor connector high
- Chafed harness making intermittent contact medium
- Moisture or corrosion in the connector medium
- Sensor with an internal intermittent fault low
Symptoms
- Warning light comes and goes
- Occasional harsh or erratic shifts
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0936
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.