P0934
Hydraulic Pressure Sensor Circuit Low
The pressure sensor signal sits below its valid window. Chrysler RFE transmissions feed the line pressure sensor with a 5 V reference and expect 0.35 to 4.75 V; P0934 sets when the signal stays at or below 0.35 V for 0.18 s, monitored continuously with the engine running. Typical reasons are a signal wire shorted to ground, a lost 5 V reference or a failed sensor. Ferrari also uses P0934 on its DCT, described as hydraulic pressure sensor signal too low. P0935 is the opposite high fault, P0932 the general circuit fault, P0933 plausibility and P0936 intermittent. Without a usable pressure signal the control usually raises pressure to a safe maximum, so shifts turn harsh.
Possible causes
- Sensor signal wire shorted to ground high
- 5 V reference open or shorted medium
- Pressure sensor or the solenoid pack carrying it failed medium
- Control module fault low
Symptoms
- Warning light on
- Harsh shifts due to default maximum pressure
- Possible limp mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0934
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.