P0933
Hydraulic Pressure Sensor Range/Performance
The pressure reading is electrically valid but does not fit the operating state. Chrysler RFE, RLE and TES transmissions set it when measured line pressure is more than 25 psi (172 kPa) above the commanded value while staying below the highest pressure ever used in that gear; Sonnax notes that a maximum-pressure condition from an open pressure control solenoid circuit can trigger it and mislead toward the sensor. Ferrari lists P0933 on its DCT as an invalid hydraulic pressure sensor signal, read in the NCR gearbox ECU. Neighbours: P0932, P0934 and P0935 are circuit faults, P0936 intermittent, P0869 a true high line pressure. The driver notices firm or harsh shifts.
Possible causes
- Open circuit or fault in the line pressure control solenoid causing real excess pressure high
- Pressure sensor drifting or reading offset medium
- Worn or sticking valves in the valve body medium
- Wrong fluid level or degraded fluid low
Symptoms
- Harsh or firm engagements and shifts
- Warning light on
- Shift quality does not adapt and may stay rough
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0933
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.