P0932
Hydraulic Pressure Sensor Circuit
General electrical fault in the circuit of the sensor that reports hydraulic pressure in the gearbox, usually line pressure in an automatic or system pressure in an automated manual or dual-clutch unit. The module sees a signal it cannot use at all, without a clear low or high pattern. Chrysler names it Line Pressure Sensor Circuit Fault; an ALLDATA case on a 2003 Grand Cherokee 4.7 automatic shows it together with P0935, caused by an open line pressure solenoid in the solenoid pack. CARB requires circuit checks on such transmission inputs. P0934 and P0935 are the low and high faults, P0933 the plausibility fault, P0936 the intermittent one. Expect harsh shifts, often with line pressure forced to maximum.
Possible causes
- Fault in the solenoid pack or valve body module that carries the pressure sensor (open solenoid, internal lead frame) high
- Poor crimp or solder joint at the sensor connector terminals medium
- 5 V reference or sensor ground interrupted medium
- Transmission or powertrain control module fault low
Symptoms
- Warning light or transmission warning on
- Harsh engagements and firm shifts from maximum line pressure
- Possible limp mode with limited gears
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0932
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.