OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0931

Gear Shift Lock Solenoid/Actuator Control Circuit A High

The control module reads a voltage on shift lock circuit A that is higher than the commanded state allows. FCA documents the code directly: in recall 16V-249 the Jefferson North plant found 2016 Jeep Grand Cherokee (WK) vehicles with active or stored P0931-00 whose selector would not release from Park. The cause was a badly crimped terminal on the BTSI solenoid harness from shifter supplier GHSP; FCA replaced the gear selector and warned that losing the solenoid could leave the lever locked in Park or Neutral. So a poor connection, not only a short to battery, can show up as High. P0930 is the low, P0928 the open fault of circuit A; P092D is the high fault on circuit B.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 31

Possible causes

  • Poorly crimped or loose terminal on the shift lock solenoid harness (FCA recall 16V-249) high
  • Control wire shorted to a supply voltage medium
  • Open shift lock solenoid coil seen as high voltage by a low-side driver medium

Symptoms

  • Selector lever will not release from Park
  • Lever may lock in Park or Neutral unexpectedly after stopping
  • Fault comes and goes with vibration or temperature

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0931

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication