P092A
Gear Shift Lock Solenoid/Actuator Control Circuit B/Open
Reports an open on control circuit B of the shift lock. No manufacturer documents this code publicly, and none says which lock is B. One possible use is a second lock actuator: GHSP patents describe shifters where a further solenoid holds the lever in Neutral below a set speed unless the brake is pressed, beside the usual Park lock. CARB requires output circuits to be checked for continuity but may exempt safety-only systems. The FCA recall on the BTSI solenoid shows how such a lock fails in practice. P0928 is the same open fault on circuit A, P092B the plausibility fault, P092C and P092D the low and high faults of circuit B. Expect a lever that is locked in a position or no longer locked.
Possible causes
- Broken wire or loose terminal on circuit B at the shifter high
- Open coil in the second lock solenoid medium
- Shifter connector not fully seated after console work low
Symptoms
- Selector lever locked in one position although the brake is pressed
- Lock no longer engages, lever moves freely without brake
- Warning message about the shifter or transmission
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P092A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.