P0927
Gear Shift Reverse Actuator Circuit High
Set when the drive circuit of the reverse shift actuator of an automated manual gearbox shows a voltage that is too high for the current switching state. Common reasons are a valve or motor line shorted to battery voltage or a driver stage that no longer switches off; on some circuit designs an open load also reads high. No manufacturer documents this code publicly. A ZF patent describes double-acting shift cylinders with a 3/2 solenoid valve on each chamber, and an Isuzu patent reverses an electric shift motor according to shift direction, so the reverse direction has its own output. CARB requires circuit checks on outputs. P0926 is the opposite low fault, P0924 the open circuit, P0923 the forward direction. A permanently energised actuator can force a gear, so shifting is usually locked.
Possible causes
- Drive wire shorted to battery voltage high
- Driver stage in the control module stuck on medium
- Open coil or winding read as high on some circuit designs low
Symptoms
- Transmission warning light on
- Gearbox locks in one gear or refuses to shift
- Possible grinding when a gear is pushed unintentionally
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0927
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.