P0926
Gear Shift Reverse Actuator Circuit Low
Set when the drive circuit of the reverse shift actuator of an automated manual gearbox, the one moving the shift mechanism opposite to the forward direction, shows a voltage that is too low for the current switching state. This usually means a valve or motor line shorted to ground or an internal short in the actuator; the module often switches the output off to protect itself. No manufacturer documents this code publicly. A ZF patent drives each chamber of a double-acting shift cylinder through its own solenoid valve, an Isuzu patent runs the shift motor in both directions. CARB requires circuit checks on outputs. P0927 is the opposite high fault, P0924 the open circuit, P0922 the forward direction. Gears in this direction are blocked.
Possible causes
- Drive wire chafed through and shorted to ground high
- Internal short in solenoid coil or shift motor medium
- Water or corrosion bridging pins in the connector low
Symptoms
- Transmission warning light on
- Certain gears can no longer be engaged
- Gearbox may stay in neutral or hold one gear
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0926
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.