P0923
Gear Shift Forward Actuator Circuit High
Set when the drive circuit of the forward shift actuator of an automated manual gearbox shows a voltage that is too high for the current switching state. Typical reasons are a valve or motor line shorted to battery voltage, or a driver stage in the module that no longer switches off; depending on circuit design an open load can also read high. No manufacturer documents this code publicly. A ZF patent describes double-acting shift cylinders whose chambers each have a 3/2 solenoid valve, and an Isuzu patent drives a shift motor forward or reverse by shift direction. CARB requires circuit checks on outputs. P0922 is the opposite low fault, P0920 the open circuit, P0927 the reverse direction. An actuator that stays energised can hold or force a gear, so shifting is usually locked.
Possible causes
- Drive wire shorted to battery voltage high
- Driver stage in the control module stuck on medium
- Open coil or winding read as high on some circuit designs low
Symptoms
- Transmission warning light on
- Gearbox locks in one gear or refuses to shift
- Possible grinding when a gear is pushed unintentionally
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0923
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.