P091D
Gear Shift Position Circuit B High
Set when the shift position signal on circuit B of an automated manual gearbox stays above its highest valid value for longer than a calibrated time. The signal line may be shorted to sensor supply or battery voltage, the sensor ground may be open, or the sensor may be faulty. No manufacturer documents this code publicly. Patents from Aisin AI and Nissan/Aichi present the shift stroke or shift position sensor as the feedback for gear engagement, so a reading above the valid band leaves the module unable to judge this channel. CARB requires out-of-range checks on such inputs. P091C is the opposite low fault, P0917 and P095D are the high faults of circuits A and C, P091B the plausibility fault of circuit B. Shifting is usually restricted.
Possible causes
- Signal wire of circuit B shorted to supply or battery voltage high
- Open sensor ground medium
- Faulty shift position sensor B medium
Symptoms
- Transmission or engine warning light on
- Restricted gear changes or a held gear
- Engine start may be blocked if neutral cannot be confirmed
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P091D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.