P091C
Gear Shift Position Circuit B Low
Set when the shift position signal on circuit B of an automated manual gearbox stays below its lowest valid value for longer than a calibrated time. Usually the signal line is shorted to ground, the sensor supply is missing, or the sensor has failed internally. No manufacturer documents this code publicly. Patents from Aisin AI and Nissan/Aichi present the shift stroke or shift position sensor as the feedback that confirms an engaged gear; with a reading below the valid band that confirmation is lost on this channel. CARB requires out-of-range checks on such inputs. P091D is the opposite high fault, P0916 and P095C are the low faults of circuits A and C, P091B the plausibility fault of circuit B. The gearbox may run in fallback mode.
Possible causes
- Signal wire of circuit B shorted to ground high
- Open or shorted sensor supply line medium
- Faulty shift position sensor B medium
Symptoms
- Transmission or engine warning light on
- Restricted gear changes or a held gear
- Engine start may be blocked if neutral cannot be confirmed
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P091C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.