P0919
Gear Shift Position Control Error
Set when the control module of an automated manual gearbox drives the shift actuator towards a gear, but the measured shift position does not reach the target within the allowed time and tolerance. Sensor and actuator circuits can be electrically intact; the fault concerns the closed loop as a whole. Usual reasons are a stiff or jammed shift rail or synchroniser, a weak actuator, low hydraulic pressure on hydraulic units, or a sensor offset. No manufacturer documents this code publicly. A Hyundai/Kia patent detects jammed shift actuators from motor current, and an Isuzu patent controls the shift motor by stroke ranges using a shift stroke sensor. CARB requires functional checks on such outputs. P0909 is the same error in the select direction, P0920 to P0927 the actuator circuits. Gears may not engage.
Possible causes
- Stiff or jammed shift rail, shift fork or synchroniser high
- Worn shift motor or leaking shift cylinder that no longer delivers full force medium
- Low pressure in the hydraulic supply on hydraulically actuated units medium
- Shift positions not relearned after actuator or module replacement low
Symptoms
- Transmission warning light on
- Gear does not engage or engages only after a delay
- Gearbox remains in neutral or locks in one gear
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0919
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.