P0918
Gear Shift Position Circuit A Intermittent
Flags a gear shift position signal on circuit A that drops out or jumps for short moments in an automated manual gearbox. The module sees implausible steps or brief losses that are too short or too irregular for a lasting low or high fault. Typical triggers are terminals that lose contact under vibration, a chafed harness moving with the powertrain, or moisture at the actuator connector. No manufacturer documents this code publicly. Patents from Aisin AI and Nissan/Aichi show the shift stroke sensor as the feedback that confirms an engaged gear. CARB requires circuit checks on such inputs. P0914, P0916 and P0917 are the steady electrical faults of circuit A, P0915 the plausibility fault. Shifts may abort or the gearbox may briefly fall back to neutral.
Possible causes
- Connector at the shift sensor or actuator unit losing contact under vibration high
- Chafed or partially broken sensor wire near the gearbox medium
- Moisture or corrosion in the connector medium
- Shift position sensor with an internal contact or track fault low
Symptoms
- Warning light comes and goes
- Gear changes abort now and then or the gearbox drops to neutral
- Fault often appears on rough roads or in wet weather
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0918
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.